SmartTouch+ Universal Controller
Explore key features and follow step-by-step setup and programming instructions below.
Universal Compatibility
Ability to program and operate all BOSS Cold Front Technology V, straight-blade, and D-Force plows.
Please note: Not compatible with 13-Pin (SL3 headlight) systems.
Instant, Seamless Response
Pairs our familiar, trusted controller design with the Cold Front Technology Snowplow for instant, precise response.
Custom Control
Seamlessly control SL4 headlights, ClearBeam, warning lights, and VBX+ on/off for enhanced visibility and operation.
Using & Setting Up Your Universal SmartTouch+ Controller
Refer to the steps below on how to operate your SmartTouch+ Controller and configure the AUX buttons.
1. Raise
2. Lower
3. On/Off Switch
4. Left Wing Out
5. Right Wing Out
6. Left Angle
7. Right Angle
8. AUX 1
9. AUX 2
10. Left Wing In
11. Right Wing In
1. Raise
2. Lower
3. On/Off Switch
4. Left Angle
5. Right Angle
6. AUX 1
7. AUX 2
With the controller turned OFF, press and hold the POWER button for 5 seconds.
The controller will enter programming mode, and the center button will flash green or red while in this mode.
- Green: Express Raise Enabled
- Red: Express Raise Disabled
To enable or disable Express Raise, push the UP button to toggle to the setting that is preferred.
Turn the controller power OFF to save your configuration
With the controller turned OFF, press and hold the POWER button for 5 seconds.
The controller will enter programming mode, and the center button will flash green or red while in this mode.
- Green: Express Raise Enabled
- Red: Express Raise Disabled
While in programming mode, cycle through the AUX buttons by pressing AUX 1 or AUX 2 to select the desired setting.
LED COLOR OPTIONS:
- BLUE LED: High Beam Toggle
- MAGENTA LED: ClearBeam ON/OFF
- ORANGE LED: Warning Lights ON/OFF
- RED LED: Spreader ON/OFF (VBX+)
- No LED: No configurations assigned
Turn the controller power OFF to save your configuration.
If one AUX button is configured to the warning lights (orange LED), the warning light pattern can be selected in the programming mode.
Refer to the steps below:
With the controller turned OFF, press and hold the POWER button for 5 seconds.
The controller will enter programming mode, and the center button will flash green or red while in this mode.
- Green: Express Raise Enabled
- Red: Express Raise Disabled
While in programming mode, press the DOWN button. The two AUX buttons will begin to flash in a pattern.
Press the UP button to cycle through the flash patterns. Stop on the desired pattern.
Turn the controller power OFF to save your configuration.
NOTE: The settings will be saved until this procedure is repeated.
