Speed Turtle 2.0 Easy Flash Module

Description

The Speed Turtle 2.0 Easy Flash Module is a small, easy to use vehicle exterior light flasher. The Speed Turtle 2.0 plugs into your vehicle’s OBD-II port and will make select factory lights flash in a variety of flash patterns. The system is easily installed in minutes and is a true plug and play solution for most vehicles. The Speed Turtle module will not damage the vehicle and can be removed at any time and you can also install in another vehicle without repairing or replacing vehicle components. With the included software you can program the module to change patterns, park mode flashing and update firmware as updates become available.

What’s in the Box:

• (1) Speed Turtle 2.0 Easy Flash Module
• (1) Toggle Switch OR (1) Voltage Input (Choose at checkout)
• 6′ Micro USB Cable
• Zip Ties

Mounting Options:

• Installs directly into your vehicle’s OBD-II port.
• Double sided tape allows you to stick the toggle switch directly to your dash

Tech Specs:

• 10 unique flash patterns
• Park mode allows you to change patterns or disable specific lights when in park.
• Two switch inputs as well as the ability to activate the module using pre-existing vehicle buttons or controllers
• Included software allows you to program which do and do not flash
• If your vehicle is equipped with these lights, the Speed Turtle 2.0 can flash:
  • Front Low Beams
  • Front High Beams
  • Front Turn Signals
  • Front Fog Lamps
  • Front LED Accents
  • Rear Turn Signals
  • Rear Stop Lamps
  • Third / Center Mounted Brake Lamp
  • Reverse Lamps
  • Rear LED Accents
  • Pickup Bed Lamp

Harness Types:

This harness provides a simple ON/OFF toggle switch with adhesive backing. There are two internal LEDs to the toggle switch with green indicating the switch is ON and orange indicating the switch is OFF. While this is the simplest of the two harnesses to install, it only provides one of the two possible switch inputs. The toggle switch harness is connected to Input 1 on the module.

This harness provides two ‘flying lead’ input wires. Each wire will accept a 5 – 17 volt input signal from a switch or light controller of your choice. The white wire corresponds to Input 1 and the green wire corresponds to Input 2.

Compatibility:

Additional information