SaltDogg Parts

The wireless remote controller conversion kit, 600DCKIT , is a single 12volt motor variable speed controller has 5 pre-set speeds in approx 1/5th increments. Comes with transmitter with glow in the dark label, rubber boot and lanyard. Receiver unit, 7 prong cord to plug into your truck receiver hitch and seal tight connectors. This unit is commonly used on single motor tailgate mounted salt sand spreaders such as Meyer, Western Low Profile, Boss TGS, SaltDogg Tailgate, Hiniker, Swenson and more. Completely replaces Meyer Part # 63930 Wireless Remote Control Kit and is hundreds of dollars cheaper! Most brands of vehicles have the battery charging pin of the 7-prong trailer plug-in activated. Many Chevrolet’s will not have the wire connected and or the fuse not installed for this function. The wire for this may be under the fuse box under the hood or taped to the wiring harness near the brake booster. Install this wire per mfg. instructions and install the proper fuse. If your vehicle is not equipped with the battery charging wire, you may add this by running a 8 or 10 gauge wire from the battery to the terminal on the truck side 7 prong plug as shown in the provided diagram. You must install a 40-amp fuse at the battery. Note 2015 and up Ford F150 and Ford 2017 and up F250,350 trucks do not have live power at the 7-prong trailer plug to operate a spreader, must use Anderson plug quick disconnect. If you do not have proper power and ground to the wireless unit it will not operate.